Cockpit DC amp meter will not indicate load when selected to bat position 737-3/4/500

Discrepancy: Cockpit DC amp meter will not indicate load when selected to battery position. All other positions indicate normal.
Possible fix: Replace broken terminal end for load meter shunt wire, located inside battery connector.
Tip: You must remove power and disconnect battery connector and separate halves of connector to install a new teminal end for the shunt wire.
Reason: a 22 gauge wire, connected to the negative lug inside the battery connector supplies current to load meter shunt which in turn provides battery load amps indication to DC amp meter, on the P-5 panel when selected to BATT position.

Thanks to Tom S. for his input !

> FOR INFORMATION ONLY. UNCONTROLLED DATA !. uses cookies to use the content and ads for functions to analyze website-traffic. also shares information about your usage on this site with our partners for social media, ads and analysis. By continuing to use this site, you agree to the use of cookies. More information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

More information about our privacy policy and cookies, see the Privacy Policy & Cookies page.

Click here to read more about how Google uses data when you use our partners' sites or apps.