After T/R actuator change reverser light is not going off upon stowing T/R. 737-3/4/500

RECTIFICATION

STEP 1 REMOVE HYDRAULIC POWER

STEP 2 REMOVE ALL SYNC SHAFTS

STEP 3 PRESSURISE HYDRAULIC

STEP 4 STOW T/R ( OBSERVED REVERSER LIGHT WENT OFF AFTER TIME DELAY AS USUAL)

STEP 5 REMOVE HYDRAULIC POWER

STEP 6 INSTALL SYNC SHAFTS

STEP 7 CARRY OUT T/R OPERATIONAL CHECK

 

> FOR INFORMATION ONLY. UNCONTROLLED DATA !.

Sjap.nl uses cookies to use the content and ads for functions to analyze website-traffic. Sjap.nl also shares information about your usage on this site with our partners for social media, ads and analysis. By continuing to use this site, you agree to the use of cookies. More information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

More information about our privacy policy and cookies, see the Privacy Policy & Cookies page.

Click here to read more about how Google uses data when you use our partners' sites or apps.

Close